Brent 1082/882 — Operation
3-11
Fig. 9
Optional Equipment
Hydraulic Drive
The optional hydraulically-driven auger permits
cart operation using tractors that are not
equipped with a PTO. However, due to the
power requirements of a grain cart, it should be
expected that a hydraulically-driven grain cart
will not unload as quickly as a PTO driven cart.
•
Depending on the option chosen, the motor is
rated for either 55 or 100 gpm hydraulic flow
at 3000 psi. Sustained flow and pressure above
these amounts will dramatically reduce motor
life. Be aware of maximum tractor hydraulic
flow and pressure before operating auger.
NOTE: A motor containing two pressure and two
return lines is a 55 GPM motor. A motor containing
three pressure and three return lines is a 100
GPM motor. If unsure of motor size, contact
your dealer providing your cart’s serial number.
(May 2013)
To Next Page
Loading...
