brent 882 - Page 65

Brent 1082/882 — Maintenance
4-17
PTO Shaft and Clutch (continued)
To Dismantle Guard (Figs. J1 - J4)
1. Remove locking screw.
2. Align bearing tabs with cone pockets.
3. Remove half-guard.
4. Remove bearing ring.
To Assemble Guard (Figs. K1 - K5)
1. Grease yoke groove and inner profi le tube.
2. Fit bearing ring in groove with recesses facing
profi le tube.
3. Slip on half-guard.
4. Turn cone until it engages correctly.
5. Install locking screw.
J2
J1
J3
J4
K4
K3
K1
K2
K5
(October 2011)