Bresser ClimateScout User Manual

27
TIME & CALENDAR
1. Date
2. Time
3. RCC signal strength indicator
4. DST
5. Alarm
6. Moon phase
7. Day of the week
RADIO CONTROLLED / ATOMIC CLOCK FUNCTION
When the unit receives RCC signal, a sync-time symbol
will appear on the LCD, and synchronizes daily.
SIGNAL STRENGTH INDICATOR
The signal indicator shows signal receive status. Flashing wave
segment means RCC signals are being received. The signal
receiving status could be classied into 2 types:
No signal quality Received RCC signal
NOTE:
- Everyday the unit will automatically search for the time signal at 2:00am, 8:00am, 2:00pm and 8:00pm
- The strength of radio-controlled time signal from the transmitter tower may be a󰀨ected by geographical
location or building around.
- Always place the console away from interfering sources such as TV set, computer, etc.
- Avoid placing the console on or next to metal plates.
- The console can more easy to received the signal, if the distance between console and the adapter is 1m or
more.
- Closed areas such as airport, basement, tower block, or factory are not recommended.
TIME SETTING
The unit automatically set itself accordingly to the Radio Controlled Clock signal it received. To set the clock/
calendar manually, rst permanently disable the reception by holding the RCC key for 8 seconds (Press RCC
key for 8 seconds again to enable the RCC reception).
TO MANUALLY SET THE CLOCK / TIME ZONE SELECTION
1. Press and hold [ TIME SET ] key for 2 seconds until 12 or 24 Hr ashes.
2. Use [ UP ] or [ DOWN ] key to adjust, and press [ TIME SET ] key to proceed to the next setting.
3. Press [ TIME SET ] key again to step the setting items in this sequence: 12/24 Hour format
Hour
Minute Second Year Month Day Hour o󰀨set Weekday Language DST
AUTO / OFF.
NOTE:
- The unit will automatically exit setting mode if no key was pressed in 60 seconds.
- DST (Daylight Saving Time) feature is set to Auto (factory set). The clock has been programmed to
automatically switch when the daylight saving time is in e󰀨ect.
- DST feature only valid when RCC function is on.
SETTING ALARM TIME
1. In normal time mode, press and hold [ ALARM ] key for 2 seconds until the alarm hour digit ashes to enter
alarm time setting mode.
2. Press [ UP ] or [ DOWN ] key to change the value. Press and hold the key for quick-adjust.
3. Press [ ALARM ] key again to step the setting value to Minute with the Minute digit ashing.
4. Press [ UP ] or [ DOWN ] key to adjust the value of the ashing digit.
5. Press [ ALARM ] key to save and exit the setting.
NOTE:
- In alarm mode, the “
” icon will display on the LCD.
- The alarm function will turn on automatically once you set the alarm time.

Bresser ClimateScout Specifications

General

Brand	Bresser
Model	ClimateScout
Category	Weather Station
Language	English