35
4. In the alert type, the selected value will ashing, than press [ UP ]
or [ DOWN ] key to adjust the value or press and hold the key to
change rapidly.
5. Press [ ALARM ] key to toggle the regarding alert on / o.
6. Press [ ALERT ] key to conrm and shift to next alert reading.
7. When you complete the setting, press and hold with 2 second to exit alert setting.
NOTE:
- If no key is pressed, it will automatically exit alert mode after 60 seconds.
- When ALERT alarm is on, the area and type of alarm that triggered the alarm will be ashing and the alarm
will sound for 2 minutes.
- To silence the Alert alarm beeping, press the [ SNOOZE ] or [ ALARM ] key, or let the beeping alarm
automatically turn o after 2 minutes.
WIRELESS SIGNAL RECEPTION
The 7-IN-1 sensor the capable of transmitting data wirelessly over an approximate operating of 150m range (line
of sight). Occasionally, due to intermittent physical obstructions or other environmental interference, the signal
may be weaken or lost. In case that the sensor signal is lost completely, you will need to relocate the Console
or the wireless 7-IN-1 sensor.
No sensor Signal searching Strong signal Weak signal Signal lost
NOTE:
The CH 1~3 optional thermo-hygro sensor signal strength indicator is same as 7-IN-1 sensor.
BACK LIGHT
This console have LCD back light, user can press the [ SNOOZE / LIGHT ] key to light up the LCD with 5
seconds.
POINTING 7-IN-1 SENSOR TO THE SOUTH
The outdoor 7-IN-1 sensor is calibrated to be pointing
to North by default. However, in some cases, users may
wish to install this sensor point to South:
1. First install the outdoor 7-IN-1 sensor with its arrow
pointing to the South.
2. On the Console, press and hold the [ WIND ] key for
8 seconds until the upper part (Northern Hemisphere)
of the compass lights up and blinking.
3. Use [ UP ] or [ DOWN ] key to change to lower part
(Southern Hemisphere).
4. Press the [ WIND ] key to conrm and exit.
Northern hemisphere Southern hemisphere
To Next Page
Loading...
Need help?
General
