— 22 — "BRIG" inflatable boats
How to operate with bilge pump:
1. Open the rear hatch
2. On the battery disconnector panel ((7) fig.D8) to the left of you, locate the bilge pump switch with fuse.
3. Select the desired operating "Auto" mode only.
4. The bilge pump will be in the active position, even if all the battery disconnectors on this panel are turned off.
5. On the switch panel on the steering console to activate the bilge pump, you can use the "Manual" mode only.
Always the cockpit drain sockets
must be open during navigation. Do
not obstruct cockpit drain sockets
at any time. Do not dispose bulky
objects in front of the cockpit drain
sockets.
It is dangerous to pretend
to be an expert. This may
cause damages. Refer to
expert and authorized
specialists for all types of
maintenance and repair.
Do not modify drain systems.
Before navigation check the
drain valves.
Never locate heavy objects
on the drain hoses. It will be
cause of bucking, distortions
and damages.
Make sure the pump is working. To do this, activate the pump by selecting the "Manual" mode.
You should hear the sound of a running pump.
Always keep the pump active in the "Auto" mode if the boat is on the water.
ATTENTION. The pump is connected to the battery.A working pump can discharge the
battery.Have on board other means for draining a boat (for example a hand pump)
To Next Page
Loading...
