— 32 — "BRIG" inflatable boats
The tube of the boat has some independent air-tight chambers. Before inflation of compartment it's necessary to set all valves in operating
condition. In order to switch valve to operating condition, just press spindle 6 (look before Fig. D3) with your finger and turn it clockwise untill
it is fixed. If it isn't possible the valve is in operating condition already.
Fill the tube compartments with air using the pump from the complete set. First fill two rear compartments, then middle compartments. Thereat,
do not bring the pressure up to its operating value (the tube will be completely straightened). Then fill the bow compartment with air up to the
rated pressure. The rated pressure value is 0.15 bar (2.2 psi). On completion of filling close the valves with caps.
In order to discharge air from the compartments, open the valves
(just press spindle with your finger and turn it anticlockwise till
it is fixed).
INFLATION/DEFLATION BOAT TUBE.
The rated pressure value is 0.15 bar (2.2 psi).
If the tube pressure more than nominal, deflate the compartments slightly. Boat exploitation with board
pressure more than nominal decreases boat service life.
Do not use compressors and/or other types of inflating equipments not approved by the boat builder.
Check tube pressure before every navigation.
Board air chambers are hermetical if they keep own form during 8 hours. In this case:
– primary pressure has to be nominal;
– input valves openings have to be tightly closed by caps.
To Next Page
Loading...
