— 24 — "BRIG" inflatable boats
HOW TO OPERATE WITH ANCHOR SYSTEM.
Before beginning to operate with anchor system, carefully study the owner's manual for electric windlass. Please, respect all requests and follow
all instructions stated in above indicated manual.
If you need to drop/cast the anchor by electric motor:
1.Disconnect main battery disconnector.
2.Open the bow anchor hatch. By means of handle (supplied) close the clutch nut (3, fig.D9).
3.Disengage safety pin (6, fig.D9) from chain.
4.Windlass circuit breaker (8, fig.D9) and battery disconnectors must be switch on.
5.By means of anchor windlass "up" and "down" switch drop/cast the anchor.
6.Switch off the main battery disconnector. Close the bow anchor hatch.
If you need to stow the anchor by electric motor:
1.Disconnect main battery disconnector.
2.Open the bow anchor hatch. By means of handle close the clutch nut (3, fig.D9).
3.Check that the safety pin (6, fig.D9) is detached from chain.
4.Windlass circuit breaker and battery disconnectors must be switch on.
5.By means of anchor windlass "up" and "down" switch begin to stow the anchor.
6. When the anchor will begin to crawl on a roller, stop windlass electric motor in order to see that the anchor is not swinging and have
occupied correct position. CHECK, THAT THE ANCHOR OCCUPIED CORRECT POSITION (Fig. D10).
7.Continue to stow the anchor, until it will be fixed on a stemhead roller.
8.Switch off windlass circuit breaker and then main battery disconnector.
9.Hook safety pin to chain. Close the bow anchor hatch.
D11
To Next Page
