Eagle 6.7-2019 236G.01
— 25 —
Always turn off the windlass circuit breaker when the windlass is not in use to prevent any accidental
engagement.
Always keep hands and feet off an operating windlass. If the chain gets blocked, turn the windlass
off and try to free the chain extremely carefully.
Periodically clean out the drain opening (7)(Fig.D9) from dirt.
Check that the chain was not twisted in the area between the anchor and the windlass.
Untwist it, if necessary.
Do not use the windlass for different purposes it was designed for.
CHECK, THAT THE ANCHOR HAVE OCCUPIED CORRECT POSITION
AND ONLY AFTER THAT CONTINUE TO STOW THE ANCHOR.
Safety pin must always been hooked to the chain when the windlass is not in use.
ANCHOR NOT CORRECT POSITION.
RESTART TO STOW THE ANCHOR.
ANCHOR CORRECT POSITION.
CONTINUE TO STOW THE ANCHOR.
D10
To Next Page
