50
2
2
On/Off Switch Light Does Not Flash
1. Check engine oil level. If low, add oil to
bring to FULL mark on dipstick.
2. Try to start engine while shading ON/OFF
switch light from bright light such as
sunlight. If light does not flash, replace
switch. If new switch still does not flash, go
to next step.
3. Check wiring of ON/OFF switch. Wire from
module with spade terminal should be on
“L” terminal. RED ground wire should be
on #3 terminal and BLACK wire from
ignition armature should be on #2
terminal.
Engine Starts and Runs With Low Oil
1. Check wiring of ON/OFF switch per Step 3
in, “Engine Will Not Start and ON/OFF
Switch Light Does Not Flash.” If wiring
is correct, proceed to next step.
2. Check for oil sensor float stuck in open
position per Step 2 in, “Engine Will Not
Start, ON/OFF Switch Light Flashes.” If
stuck, replace. If not stuck, proceed to
next step.
3. Check for opens in wiring. If no opens.
replace module.
To Next Page
Loading...
Need help?
General
