12 BRIGGSandSTRATTON.COM
Applying Detergent
WARNING Chemical Burn Hazard.
Chemicals could cause burns resulting in
death or serious injury.
• Always wear indirect vented (chemical splash) safety goggles
marked to comply with ANSI Z87.1 when using chemicals.
• DO NOT substitute safety glasses or dry-condition goggles
for indirect vented safetygoggles.
• DO NOT use caustic liquid with electric pressure washer.
• Use ONLY pressure washer safe detergents/soaps. Follow all
manufacturers instructions.
To apply detergent, follow these steps:
1. Review use of 7-in-1 nozzle shown in How to Use 7-in-1
Nozzle.
2. Prepare your detergent solution as required by job to be
performed.
3. Remove cap from each detergent tank.
4. Fill each tank with detergent solution.
5. Place cap back onto each detergent tank.
6. Turn detergent selector switch (A) to select desired detergent.
7. Make sure one of the soap spray pattern nozzles is selected
on 7-in-1 nozzle.
NOTICE Detergent cannot be applied with high pressure nozzles
(maximum, general, delicate, fan spray or extended reach).
8. Make sure garden hose is connected to water inlet. Check that
high pressure hose is connected to spray gun. Turn on water.
NOTICE You must attach all hoses before you start the pressure
washer.
9. Uncoil high pressure hose completely from hose reel.
10. Start the pressure washer as instructed in How to Start Your
Electric Pressure Washer.
11. Apply detergent to a dry surface, starting at lower portion
of area to be washed and work upward using long, even,
overlapping strokes.
12. Allow detergent to “soak in” for 3-5 minutes before washing
and rinsing. Reapply as needed to prevent surface from
drying. To prevent streaking, Do Not allow detergent to dry on
surface.
Electric Pressure Washer Rinsing
1. Select desired high pressure nozzle following instructions
How to Use 7-in-1 Nozzle.
2. Keep spray gun a safe distance from area you plan to spray.
WARNING Risk of kickback.
Spray gun could kickback causing you to fall resulting
in death or serious injury.
• Operate the electric pressure washer from a stablesurface.
• Be extremely careful if you must use the electric pressure
washer from a ladder, scaffolding, or any other similar
location.
• Firmly grasp spray gun with both hands when using power
spray modes to avoid injury when spray gun kicks back.
3. Apply a high pressure spray to a small area and then check
surface for damage. If no damage is found, you can assume it
is okay to continue rinsing.
4. Start at top of area to be rinsed, working down with same
overlapping strokes as you used for cleaning.
Other Cleaning Tips
• NEVER leave the electric pressure washer unattended while
it is plugged into an electrical outlet and while water is
supplied to the equipment.
• If you have the nozzle too far away from the surface being
washed, the cleaning may not be as effective.
How to Store Accessories
The unit is equipped with an accessory tray with places to store
your spray gun, nozzle extension, 7-in-1 nozzle and power cord.
Identify all accessories with the illustrations in Features and
Controls.
A
To Next Page
Loading...
Need help?
General
