BRIGHT 025971 - Use; Automatic Charging; Start;Stop;Sleep Modes

EN
40
USE
1. Place the charging station against a wall
and make sure there are no obstacles
within 1 metre to the left and right, and
2metres in front of the charging station.
2. Connect the mains plug to a suitable
power socket. The charge indicator light
on the charging station comes on
FIG. 5
3. Press and hold the button to turn the
vacuum cleaner on or o.
4. Push the button on the vacuum cleaner
or the charging button on the remote
control when the cleaner is in standby or
cleaning mode. The vacuum cleaner goes
automatically to the charging station for
charging.
NOTE:
• The vacuum cleaner will stop charging
and start cleaning when the button
on the vacuum cleaner or the start/stop
button on the remote control is pushed
while the vacuum cleaner is charging.
• Charge the vacuum cleaner for at least
12 hours before using it for the rst time.
• During normal use, the vacuum cleaner
should be docked at its charging station
when not being used and the charging
station must be connected to the mains
power.
• If the vacuum cleaner stops, check the
charging status of the battery.
• If the vacuum cleaner is not going to be
used for some time, turn it o by
pressing and holding the button until
the cleaner turns o.
AUTOMATIC CHARGING
• When the battery has discharged, the
vacuum cleaner automatically returns to
the charging station for charging.
• Check that the charging station is
connected to the mains power and that
there are no obstacles in the way.
Otherwise the vacuum cleaner may have
diculty nding the charging station.
• The vacuum cleaner may move forwards
and backwards 3 or 4 times at the
charging station to nd the best position
before charging begins.
START
/
STOP
/
SLEEP
• Sleep mode: The button light is o, the
vacuum cleaner is not cleaning.
• Standby mode: The button light is
blinking, the vacuum cleaner is not
cleaning.
• Cleaning mode: The button is lit up,
the vacuum cleaner is cleaning.
Start
Tap the button to start or pause the vacuum
cleaner.
NOTE:
When the vacuum cleaner is in sleep mode,
push the button or the start/stop button
on the remote control to switch to standby
mode. Push the button again, or the start/
stop button on the remote control, to start
the vacuum cleaner.
Stop
Stop switches the vacuum cleaner from cleaning
mode to standby mode. To do this, either:
– Push the start/stop button on the
remote control.
– Push the button on the vacuum
cleaner.
– Tap the start/stop button in the app.
Sleep mode
The vacuum cleaner automatically goes into
sleep mode after 1 or 2 minutes of no activity.