BRIGHT 025971 - Cleaning the Roller Brush; Replacing the Battery

EN
43
3. Hold the tab in the middle of the primary
lter and pull it out. Remove the HEPA
lter (C).
4. Empty the dust container. If necessary, tap
the dust container gently to get the dust
out (D).
5. Clean the dust container, primary lter
and the HEPA lter carefully. Clean the
primary lter every 15 to 30 days. The
HEPA lter has a life of approx. 6 months.
Do not attempt to clean the HEPA lter
by brushing it. Blow the HEPA lter clean
or gently tap it to clean it. Do not wash it
with water (E).
6. Assemble all parts correctly before starting
the vacuum cleaner. Never use the
vacuum cleaner without the HEPA lter
and primary lter in place. Doing so may
damage the vacuum cleaner (F).
FIG. 19
NOTE:
• Clean the dust container and air inlet
grilles after each use.
• Allow all the parts to air dry completely
in the shade before reattaching them to
the vacuum cleaner. Do not expose the
parts to sunlight.
• If the primary lter and the HEPA lter
become damaged they must be replaced
to maintain optimum cleaning
performance.
CLEANING THE SENSOR WINDOW
AND CHARGING CONTACTS
1. Carefully clean the vacuum cleaner’s
sensor window and charging contacts
with the cleaning tool or a soft cloth.
A. Sensors
B. Charging contact
2. Clean the charging station’s charging
contacts with the cleaning tool or a soft cloth.
C. Charging contacts
FIG. 20
CLEANING THE ROLLER BRUSH
1. Press both the release buttons and
remove the roller brush cover (A).
2. Take hold of one end of the roller brush
and lift the brush out (C).
3. Remove any hair, dust, etc. caught in the
roller brush using the cleaning tool. Make
sure not to lose the rubber ring over the
roller.
4. Ret the roller brush and cover.
FIG. 21
REPLACING THE BATTERY
1. Press and hold the start button to turn o
the vacuum cleaner.
2. Remove the battery cover (A) and screws
(B) on the bottom of the vacuum cleaner
with a screwdriver.
FIG. 22
3. Pull on the tab to lift the battery out.
4. Gently press the battery connection catch to
loosen the battery from the vacuum cleaner.
FIG. 23
5. Insert the new battery’s contact points
into the battery connection. The battery
wires have the same colours as the wires
on the vacuum cleaner and the battery
can only be connected in one way.
FIG. 24
FIG. 25
6. Put the new battery in the battery
compartment with the text facing up.
7. Place the wires next to the battery and
replace the battery cover.
8. Start the vacuum cleaner and check that
it is working properly.
NOTE:
Charge new batteries for at least 12 hours
before using them for the rst time.