EN
42
10. If it is not possible to connect the vacuum
cleaner in the normal way, try connecting
it in the app mode.
11. Select “Small appliances” – “Cleaning
robot (Wi-Fi)”, enter the WiFi password
and tap “Next” to reset the device. Press
and hold the button until you hear a
beep and the indicator light in the button
starts to blink rapidly.
12. Release the button when you hear a
second tone. The indicator light in the
button starts to blink slowly to show that
resetting has completed.
13. Press “Next”. Select “Hotspot Network” on
your phone to open the network settings
screen.
14. Press “Connect” to go to WiFi settings and
select “SmartLife-XXXX” to return to the
“Smart Life” app. Wait until the network
connection has completed. Repeat
the above steps if a Connection Failed
message is displayed on your phone.
FIG. 12
15. When the device has been added, tap
“Finish” to go to the list of devices. Tap on
the vacuum cleaner that has been added
to the list in order to open the control
interface. The white indicator light in the
charging button goes out when the device
has been correctly added.
FIG. 13
16. Tap “Schedule” to activate scheduling
mode. Tap “Add” to set the time and
number of repeats.
17. The vacuum cleaner starts automatically
at the set time.
18. Deactivate scheduled cleaning by deleting
the settings in scheduling mode.
FIG. 14
19. Press the button to set the suction power.
FIG. 15
20. Press the button to view the options
below:
– Press “Cleaning Records” to view
recorded cleanings.
– Press “Find Robot” to activate the
localisation feature. The vacuum
cleaner emits a beeping sound to
make it easier to locate it.
FIG. 16
21. Other screen views:
– “Personal Center”: Use this screen to
set usernames, share the device with
others, and give feedback on use.
– “More pages”: Use this screen to
change the device name, view device
information, give feedback or
remove the device.
FIG. 17
22. If the vacuum cleaner is not going to be
controlled using the app, press and hold
the button to exit the app control mode.
FIG. 18
MAINTENANCE
CLEANING THE SIDE BRUSHES
If necessary, clean the side brushes with water.
Allow to dry completely before retting them.
Replace the side brushes if they become
damaged or are not working properly.
NOTE:
Be sure to place the side brush marked L on the
left-hand side, and the side brush marked R on
the right-hand side of the vacuum cleaner.
CLEANING THE DUST CONTAINER
AND FILTER
1. Press the release button for the dust
container and pull the dust container out
in the direction of the arrow (A).
2. Open the dust container lid. If the dust
container is very full, empty out some
of the dust without opening the dust
container (B).
To Next Page
Loading...
