BRIGHT 025971 - Vacuum Cleaning Modes; Smart Vacuum Cleaning; Spiral Vacuum Cleaning; Edge Cleaning

EN
41
NOTE:
If the vacuum cleaner is not going to be used
for some time, turn it o by pressing and
holding the button until the cleaner turns
o.
VACUUM CLEANING MODES
Smart vacuum cleaning
The vacuum cleaner’s default mode.
In cleaning mode, press the mode button on
the remote control and select smart cleaning
mode to start the vacuum cleaner (A).
Spiral vacuum cleaning
Place the vacuum cleaner on the area to be
cleaned. Press the mode button on the remote
control and select spiral cleaning mode to start
the vacuum cleaner (B).
Edge cleaning
In standby or cleaning mode, press the mode
button on the remote control and select edge
cleaning mode to start the vacuum cleaner (C).
FIG. 6
NOTE:
• Even if a specic mode is selected, the
vacuum cleaner can automatically
switch to other cleaning modes,
depending on the circumstances, to
achieve the best results.
• Cleaning can be cancelled at any time, in
any cleaning mode, by pushing the
start/stop button on the remote control
or the button on the vacuum cleaner.
• Cleaning can be cancelled at any time, in
any cleaning mode, with the start/stop
button in the app or by pushing the
button on the vacuum cleaner.
CONNECTING TO THE APP
1. Scan the QR code to download and install
the app.
FIG. 7
2. Register with your mobile phone number
or email address. Enter the verication
code that you receive, enter the password
and complete registration.
FIG. 8
Open the app and tap “Add device” or the “+”
symbol at the top right of the home screen.
FIG. 9
3. Select “Small appliances” – “Cleaning
robot (Wi-Fi)”, enter the WiFi password
and tap “Next” to reset the device.
4. Press and hold the button until you
hear a beep, then release the button.
The indicator light in the button “XXXXX”
starts to blink rapidly. Tap “Next” to
complete the reset process.
5. Select “Wi-Fi Quick Connection” on your
phone and tap “Next” to enter standby
mode. Repeat the above steps if a
Connection Failed message is displayed
on your phone.
FIG. 10
6. Activate Bluetooth on your phone, then
press and hold the button on the
vacuum cleaner for 3 seconds.
7. Release the button when you hear a
beep. The indicator light on the vacuum
cleaner is blinking rapidly. Mark “Conrm
the indicator is blinking” on your phone
and tap “Next”.
8. Enter the WiFi password and tap “Next” to
enable the search.
9. Tap to connect when the device has
been found. Repeat the above steps if a
Connection Failed message is displayed
on your phone.
FIG. 11