25
•
•
•
•
•
•
lighton #
or
lightoff #
Use the lighton and lightoff commands to set or clear one of the GPIO outputs.
•
For the HD410, HD810, and HD1010, the number can be any integer between 0 and 7. For
example:
lighton 3
sets LED 3 on the button board.
•
For the HD2000, the number can be any integer between 17 and 22. For example:
lighton
17
sets LED 0 on the button board.
waitbuttonany (HD410, HD810, HD1010, and HD2000 only)
Use this command when you want the playlist to pause until any GPIO buttons is pressed.
pause #
Use this command when you want the playlist to pause for a specified number of seconds.
The number must be an integer. For example, to pause for 5 seconds, the command would be:
pause 5
stop
Use this command to stop playback of the playlist.
To Next Page
Loading...
