20
•
•
•
•
•
•
Playlist commands
Here is the list of commands that you can use in a playlist:
BMP, MP3, MPG (HD2000 only), VOB (HD2000 only), TS (HD110, HD210, HD410, HD810, and
HD1010), PNG, JPG
Any line that is a file name and that ends in one of these extensions is valid. Names may contain
spaces.
debug
Use this command to view debug information on the display (serial port).
rem <comment>
Any line starting with rem is ignored, so you can include comments in your playlist. Rem is short
for
remark
.
print <line to print to console>
Use this command to send a line of text to the display. This command is useful for debugging.
(HD2000 only) audiomode #
(default is 1)
BrightSign provides 5.1 audio decoding that is controlled via the audiomode command. If your
audio source is a video file, you can use any of the following audiomode commands:
•
audiomode 0:
Provides decoded 5.1 surround sound (via USB or all six analog outs).
•
audiomode 1:
Mixes down 5:1 surround sound to stereo.
•
audiomode 2:
Mutes the audio.
(HD2000 only) audiooutput #
(default is 0)
BrightSign has 5 different audio outputs. If an output is not specified, BrightSign uses analog
audio 0 in stereo as the default. Of the 5 outputs, there are five audiooutput modes that are set
with the audiooutput command. The audiooutput command can have one of the following
values:
•
0:
Outputs analog audio.
To Next Page
Loading...
