90
•
•
•
•
•
•
•
HD410, HD810, and HD1010
•
115200 baud
•
8 data bits
•
No parity
•
1 stop bit
•
NO flow control
•
TTY mode enabled
4 Create a CF/SD card with some test files on it (BMP graphics, 48
kHz
MP3 files, MPEG-2 video,
etc), and then insert the card into the BrightSign unit you connected to your PC.
5 Connect speakers and/or a monitor to BrightSign.
6 Turn on your BrightSign.
7 After a few moments you should see the BrightSign shell appear. It should also show you the
software version number.
NOTE:
The current version of BrightSign software does not support hot-swapping of CF/SD cards.
You must insert the CF/SD card before applying power.
Shell commands
With the shell running, you can view a list of shell commands by typing: help <enter>. Type the
command on a line by itself for more information on a particular command.
Example shell commands: playing files and changing settings
For a Directory of the cards contents use:
dir
To show the contents of a sub-directory named images, use:
dir images
To Next Page
Loading...
