BrightSign HD110 - Testing CF;SD Cards

92
•
•
•
•
•
•
To explicitly refer to a card from within a script, use the following:
• For compact flash cards
CF:/
• For SD cards
SD:/
When BrightSign runs an AUTORUN.BRS script, it sets the current drive to the drive containing
AUTORUN.BRS, so references to files on the same card do not need the CF:/ or SD:/ prefixes.
Testing CF/SD cards
BrightSign works with most CF/SD cards, but is not compatible with all CF/SD cards. You can test
your card by using the dir / shell cmd, and/or using the shell cmd readperf .
Examples:
dir
readperf bigfile.ts
If the dir command fails, you get the following result:
Roku> dir /
opendir[/]
Error: can't open dir
If the readperf command fails, you get the following result:
Roku> readperf bigfile.ts
SET FEATURES transfer mode SUCCEEDED
Unable to open file ATA:\autorun.brs