23
•
•
•
•
•
•
Viewmode <setting>
(default is 0)
You can use a view mode that is different from the default by setting the mode prior to starting
video playback. The view_mode values are:
•
0:
Scales the video to fill the screen without maintaining the aspect ratio. Images may appear
stretched.
•
1:
Centers the image and adds black borders. This is also referred to as
letter boxed
video. The
aspect ratio is maintained.
•
2:
Centers the image and fills the screen. The aspect ratio is maintained.
imagemode #
(default is 0)
The imagemode command specifies whether the image is scaled to the display.
•
imagemode 0:
Centers the image without scaling (may result in cropping if the image is
larger than the current videomode resolution).
•
imagemode 1:
Scales the image to fit the display. The whole image is displayed as large as
possible with correct aspect ratio.
•
imagemode 2:
Scales the image to fill the display while maintaining aspect ratio.
•
imagemode 3:
Scales the image to fill the screen without maintaining aspect ratio.
slideinterval #
(default is 3)
Set the number of seconds between slides. The number must be an integer. For example:
slideinterval 3 inserts a 3-second pause between slides.
transition #
(default is 0)
Set the transition between images. Transition commands include:
•
0:
Changes images immediately with no transition.
•
1 to 4:
Wipes the image from top, bottom, left, and right.
•
5 to 8:
Explodes the image from the center, top left, top right, bottom left, and bottom right.
•
10 to 11:
Divides the image into vertical and horizontal venetian blinds.
•
12 to 13:
Comb the image both vertically and horizontally.
To Next Page
Loading...
