10
Clean the Reservoirs
The reservoirs should be cleaned every 3 to 4 months to remove mineral buildup and optimize dispenser performance.
Gather the following supplies:
• 200g (approx. 1.5 cups) citric acid crystals
• Hot water
• Large bucket or empty 5-gallon bottle
• Container or cup
• Clean dry cloth
A. Turn the hot, cold, and night light switches to the OFF position,
and unplug dispenser.
B. Remove the water bottle, then move the dispenser away from
the wall to gain access to the back.
C. Plug the dispenser back in and drain remaining water from the
reservoirs by dispensing from all the taps into a container.
D. Pour citric acid crystals, then 2 gallons of hot water into the
5-gallon bottle or bucket. Stir or agitate briefly to mix.
E. Insert the bottle adapter tube into the bottle or bucket with
the solution, secure the cap if using a bottle, and slide into
dispenser, shutting door securely.
F. Allow the cleaning solution to fill the reservoirs.
Then dispense a small amount of the solution
from each tap into the cup or container.
G. Wait 20 minutes, then drain the reservoirs as
described in step C. Rinse out the solution bottle
or bucket, then fill with 2 gallons of fresh hot tap
water and repeat process described in step E.
Allow reservoirs to fill.
H. Place a 3-gallon bucket at the back of the dispenser.
Remove the drain plug while simultaneously
pressing the dispense buttons. Once reservoirs
have been drained, replace drain plug.
I. Return dispenser to its location, install a fresh bottle
of water, and turn hot and cold switches ON.
J. If any odor or taste persists after cleaning, repeat
the above steps using 2 cups of white vinegar and
2 gallons of water.
To Next Page
Loading...
