9
3. Follow the steps in Connect a Water Bottle to install your new water bottle.
4. Recycle the empty bottle at your local exchange center to receive your next bottle at a discount.
Troubleshooting
Problem Solution
The cold water is not cold.
• It takes up to one hour after setup to dispense cold water.
• Make sure the power cord is properly connected to a working outlet.
• Make sure the back of the dispenser is at least 8 in. (20 cm) from a wall and there is free airflow
on all sides of the dispenser.
• Make sure green power switch on back of dispenser is On.
• If water still isn’t cold, call customer service at +1 844-257-4103 for assistance.
The hot water is not hot.
• It takes 15-20 minutes after setup to dispense hot water.
• Make sure the power cord is properly connected to a working outlet.
• Make sure red power switch on back of dispenser is On.
The night light is not working.
• Make sure the power cord is properly connected to a working outlet
• Make sure the night light power switch on back of dispenser is On.
The dispenser is noisy.
• Ensure the dispenser is located on a level surface.
• The heating tube may be generating a slight noise. This is normal.
The bottle is leaking.
• Ensure the bottle is installed correctly.
• Check to see if the bottle is cracked or broken. If so, replace the bottle.
The dispenser is not
dispensing water.
• Check to see if the bottle is empty and replace with a new bottle if necessary.
• There may still be air in the tank. Press and hold the water taps to remove air until water begins
to flow.
Cleaning and Maintenance
The Self-Cleaning UV Feature
This dispenser runs on a continuous UV cleaning cycle. It works for 40
minutes (UV icon on the display is on), turns o for 140 minutes, and then
comes back on again. This cycle continuously repeats as long as the
dispenser is plugged in and on.
Care and Maintenance
• Keep this dispenser in a dry and cool place and avoid direct sunshine.
• Ensure the back of the dispenser is at least 8 in. (20 cm) away from the wall.
• Never put the dispenser on paper or foam, which may store water and then cause creepage. Never put
anything flammable beside this machine.
• Do not use the dispenser outdoors or in a place that can be splashed by water.
• If the dispenser is not in use for longer than a 24-hour period, turn o the heating and cooling switches to
save power and drain any remaining water.
• Clean your cabinet, controls, bottle probe and spout each time you change your water bottle. Use a clean soft
cloth and a food grade sanitizer or bleach.
• Empty and clean the drip tray and grid as needed.
To Next Page
Loading...
