Bristan Artisan - Installation Requirements

Installation Requirements
Installation RequirementsInstallation Requirements
Installation Requirements
IMPORTANT
IMPORTANT IMPORTANT
IMPORTANT -
--
- PLEASE READ
PLEASE READPLEASE READ
PLEASE READ
This/these fitting/fittings needs/need to be installed in accordance with the following
This/these fitting/fittings needs/need to be installed in accordance with the following This/these fitting/fittings needs/need to be installed in accordance with the following
This/these fitting/fittings needs/need to be installed in accordance with the following
Installation Requirements and Notes (IRN) to ensure they meet the requirements of the
Installation Requirements and Notes (IRN) to ensure they meet the requirements of the Installation Requirements and Notes (IRN) to ensure they meet the requirements of the
Installation Requirements and Notes (IRN) to ensure they meet the requirements of the
Water Supply (Water Fittings) Regulations 1999 and the Scottish Byelaws 2004.
Water Supply (Water Fittings) Regulations 1999 and the Scottish Byelaws 2004.Water Supply (Water Fittings) Regulations 1999 and the Scottish Byelaws 2004.
Water Supply (Water Fittings) Regulations 1999 and the Scottish Byelaws 2004.
IRN
IRN IRN
IRN R001
R001R001
R001
See text of entry for Installation Requirements or Notes.
IRN
IRN IRN
IRN R006
R006R006
R006
This tap or combination tap assembly has a Type AUK3 air gap and is therefore for installation
in any premises to protect against a backflow risk up to a Fluid Category 5.
IRN
IRN IRN
IRN R010
R010R010
R010
Water supplies shall be a reasonably balanced pressures from a common source (e.g. hot and
cold supplies both from the same storage or both from a supply pipe). Where the fitting is
cold supplies both from the same storage or both from a supply pipe). Where the fitting is
supplied from unbalanced supplies (e.g. hot and cold supplies from separate sources) a
‘Listed’ single check valve
‘Listed’ single check valve‘Listed’ single check valve
‘Listed’ single check valve or some other no less effective backflow prevention device shall
be fitted immediately upstream of both hot and cold water inlets.
04