Bristan Capri - Page 14

♦ Regulators can be fitted if water economy is required.
*
**
* Yellow (5 litre) regulator may not be necessary on some gas water heaters.
** Important:
** Important: ** Important:
** Important: It is a requirement of Instantaneous Electric Heaters that a stable flow
of water passes through the heater. This requirement can be satisfied by using a ‘flow
stabiliser’ fitted prior to the heater and should be adjusted to give a temperature of
between 45 – 50°C from the heater.
Flow regulators are factory fitted.
Study the table on the previous page and
decide which flow regulators are
required for your particular situation.
Unscrew both inlet elbows from the valve
body and remove flow regulator/s using
Flow Regulators
Non Return Valve
Retainer
body and remove flow regulator/s using
long nose pliers from the non return valve
retainer.
Screw inlet elbows back into the valve body.
Inlet
elbow
Compression
nut
Filter
Flow Regulator
14 Need help?
Need help? Need help?
Need help? Give us a call on 0844 701 6273
0844 701 6273 0844 701 6273
0844 701 6273 and speak to one of our trained advisors.
Olive
Non Return
Valve
Non Return Valve
Retainer