To Next PageTo Next PageWhat to do if water does not come out of the showerhead when using the Bristan Java bath shower mixer?
If water does not come out of the showerhead when using the Bristan bath shower mixer, make sure the diverter mechanism is fully open by pulling the diverter knob up. Also, check the water pressure or header height, referring to the specification section for minimum pressures required.
Why is my Bristan Java Kitchen & Bath Fixtures tap constantly dripping?
If your Bristan Kitchen & Bath Fixtures tap is constantly dripping or leaking when not in use, it could be due to the cartridge or valve not fully shutting off. You should service the fitting and replace the cartridge or valve, referring to the maintenance section.
What to do if my Bristan Java Kitchen & Bath Fixtures fitting does not turn on?
If your Bristan Kitchen & Bath Fixtures fitting does not turn on, first ensure that the water supplies are turned on. Also, check whether the stop or service valve is closed, and if so, open it.
How to fix no flow or poor flow rate in Bristan Java?
If you're experiencing no flow or a poor flow rate with your Bristan Kitchen & Bath Fixtures, start by checking if the stop or service valve in the water supply pipework to the tap is partially closed; if it is, open it fully. Also, it is important to refer to the Specification section for minimum pressures required. Another potential issue could be an airlock or blockage in the supply pipework. Try removing the water supplies from the fitting and flush the system to remove any airlocks or debris. Finally, the cartridge or valve may not be opening fully, in this case service the fitting referring to maintenance section.
General| Brand | Bristan |
|---|---|
| Model | Java Series |
| Category | Kitchen & Bath Fixtures |
| Language | English |
Crucial safety precautions and warnings for installation and use of the tap range.
Technical specifications including operating pressure and compliance standards for the taps.
Physical dimensions for 1/2 inch and 3/4 inch basin and bath taps.
Physical dimensions for the bath filler and bath shower mixer taps.
Regulatory requirements and notes for fitting water supply fittings correctly.
Step-by-step installation guide for 1/2" and 3/4" basin and bath taps.
Installation instructions for the Bristan bath filler tap.
Installation guide for the Bristan bath shower mixer.
Guidance on cleaning Bristan fittings to maintain their finish and prevent damage.
Instructions for cleaning showerheads and servicing tap valves.
Solutions for common problems like no flow, dripping, or leaks.
