16
MEDIA INSTALLATION
1. MEDIA INSTALLATION (WHEN NECESSARY).
Models 250 or 300 media are shipped with separate media in pails or
boxes. Models lower than 2 CF of media come loaded
with media and this step can be skipped for new installation.
THE RISER
(DISTRIBUTOR)
REMAINS
INSIDE THE
TANK SEATED
IN THE
DEPRESSION
AT THE
BOTTOM
B) Temporarily plug the open end of the riser tube. This
ensures that no resin or gravel falls down into the
distribution. The riser (distributor) remains inside the
tank seated in the depression at the bottom.
Plug tube with a tape. Remove after media is loaded.
C) Fill support bed first. The media will not always
spill down inside the tank and may need to be
swept inside.
The large funnel makes filling the tank easier and
neater. (Or an empty 1 gallon or 4 liter container
with the bottom cut out makes a good funnel.)
A) Remove cap to Pressure Tank
PLUG
THE
RISER
TUBE
The 8”, 9” and 10: tank
media is pre-installed.
Go to Step 4
NOTE
CAUTION
The unit should be
de-pressurized before
installing or replacing media
To Next Page
Loading...
