Installation: Rear-Facing
12
Rear-Facing
Lap-Shoulder Belt Installation
• Figure A illustrates a typical rear-facing
lap-shoulder belt installation.
•
When not in use, always store the LATCH
connectors in storage pouches sewn in
cover above rear-facing lock-offs.
1 Place the child restraint rear-facing and
in full recline position on the vehicle seat.
2 Open rear-facing lock-off farthest from
where the vehicle belt will be buckled.
3
Pull the vehicle belt out, then pass it
through the first rear-facing belt slot
(Fig.
B)
.
•
The vehicle belt can be routed over or
under the cover.
4
Route vehicle belt behind and under
the buckle strap, then through the
second rear-facing belt slot.
5
Verify that the vehicle belt is not
twisted, then buckle (
Fig. C)
.
6 Push the restraint firmly into the seat
while removing slack from the lap portion
of the vehicle belt, then the shoulder
portion
(
Fig. D).
B
C
A
To Next Page
Loading...
