Installation: Forward-Facing
18
Forward-Facing
Lap-Shoulder Belt Installation
• Figure A illustrates the forward-facing lap-
shoulder vehicle belt route.
•
When not in use, always store the LATCH
connectors in storage pouches sewn in
cover above rear-facing lock-offs.
1 Place the child restraint forward-facing
on the vehicle seat.
•
Restraint must be in the full upright
position when installed in forward-facing
mode with children over 33 pounds (15kg).
•
Installation can be improved by the use of
the Versa-Tether
®
(see pages 23–25).
2
Pull the vehicle belt out, then pass it over
the LATCH bar, through the forward-facing
belt slots, then over the LATCH bar on the
other side
(Fig. B)
.
3
Verify that the vehicle belt is not
twisted, then buckle (
Fig. C)
.
B
A
C
To Next Page
Loading...
