• Do not place articles on or against this appliance
• Do not use or store flammable materials near this appliance
• Do not spray aerosols in the vicinity of this appliance while it is in operation
• Do not modify this appliance
1.4 Codes / Regulations
Brivis ICE units must be installed, serviced or repaired in accordance with these instructions and related
regulations, codes, standards, and authorities. These include but may not be limited to:
• Ozone Protection and Synthetic Greenhouse Gas Management Regulations 1995
• AS/ NZS 1677.2 - Australian Standard, Refrigeration systems, safety requirements for fixed
applications
• AS 4211.3 Gas recovery or combined recovery and recycling equipment
• HB 276-2004 : A Guide to Good Practice for Energy Efficient Installation of Residential Heating,
Cooling & Air Conditioning Plant & Equipment
• AS 4254 - Ductwork for air-handling systems in buildings
• AS/NZS 5141 – Residential Heating and Cooling Systems
• Local Electricity Authority
• Local Building Regulations
• Environment Authorities
• Building Code of Australia (BCA)
• Brivis “SuperSizeGuide” / Brivisize
It is recommended the Brivis “SuperSizeGuide” / Brivisize be followed in estimating cooling requirements
and for system design that will result in efficient installation and provide a higher level of comfort and
economical operation. Brivis assumes no responsibility for equipment installed in violation of any code or
regulations and these installation instructions.
Note: The communication cable installed between the Icebox coil and outdoor unit shall be:
1. Field supplied
2. 2-core shielded cable
3. Earthed at the CDU end, refer to Diagram 15.
Failure to do so may prevent the correct operation of the unit
To Next Page
Loading...
Need help?
General
