Need help?Do you have a question about the Brivis ICE DONSC13Z7 and is the answer not in the manual?
Overview of the Brivis ICE R410a Inverter Range and installation prerequisites.
Details the Brivis Inverter ICE as a split-only air conditioner for use with compatible Brivis Gas Heaters.
Essential safety precautions and warnings to prevent injury and equipment damage during operation.
List of relevant standards, regulations, and authorities governing unit installation and servicing.
Identification and description of the main components of the Brivis ICE system.
Details on the indoor unit, its features, and installation requirements, including handling nitrogen charge.
Instructions for installing starting collars onto the indoor unit for ductwork connection.
Guidelines for installing the P-trap assembly for condensate drainage from the indoor unit.
Visual identification of the outdoor units for the Brivis ICE series.
Diagram and notes illustrating the general layout for typical indoor unit installation.
Comprehensive guide for installing the indoor unit, covering location, connections, and airflow.
Criteria for selecting a suitable location for the indoor coil unit, considering drainage and access.
Instructions for installing the primary condensate drain and the optional safety drain tray.
Requirements for maintaining adequate clearance for servicing the indoor unit.
Details on power supply, control wiring, and communication cable connections for the indoor unit.
Guidelines for designing ductwork and the overall system for optimal airflow and performance.
Procedure for mounting the heater thermistor in the indoor unit's discharge outlet.
Requirement for fitting and accessing an air filter for the system.
Dimensional drawings and layout for various indoor unit models.
Procedures for correctly installing the outdoor condensing unit.
Criteria for selecting the optimal location for the outdoor unit, considering noise and ventilation.
Guidelines for the electrical connection of the outdoor unit, including supply and safety measures.
Instructions for connecting the thermostat control wiring between units.
Schematic diagrams illustrating the wiring connections for the indoor and outdoor units.
Dimensional drawings and required clearances for outdoor unit installation.
Essential procedures and precautions for handling refrigerant and pipe-work.
Guidelines for designing refrigerant pipe-work, including insulation and loop requirements.
Detailed instructions for connecting the refrigerant pipes using sweat or flare methods.
Procedure for evacuating the system using a vacuum pump to remove air and moisture.
Steps for charging the system with R410a refrigerant and confirming correct charge levels.
Comprehensive guide for starting up and commissioning the Brivis ICE system.
Description of how the system operates in ventilation and cooling modes.
Tables detailing cooling capacity ratings based on different temperature and airflow conditions.
Technical data sheet for the Brivis ICE Inverter, including system and unit specifications.
A form to record system details and operation characteristics during commissioning.
Welcome and overview of the Brivis ICE Add-On cooling split system and manual.
Information on how Brivis collects and uses personal information from customers.
Explanation of the operational principle of the Brivis ICE system for cooling.
Guide to operating the Brivis Networker wall control for heating and cooling modes.
Explanation of the symbols displayed on the Brivis Networker for system status and operation.
Instructions on how to operate the system in fan-only mode for air circulation.
Information on how to interpret and respond to fault codes displayed by the Networker.
Procedure for locking or unlocking the Networker control panel using a PIN.
Instructions for resetting the Networker PIN numbers to the default setting.
Guidelines for performing periodic maintenance and understanding the product warranty.
Information about the Brivis Care Program for ensuring optimal system performance.
Details on how to join the Brivis Customer Care Program for preventative maintenance.
Instructions for registering the product warranty online or via mail.
Defines terms and conditions related to the product warranty in Australia and New Zealand.
Detailed terms and conditions of the Brivis product warranty.
Exclusions and limitations of the Brivis product warranty.
Details on costs associated with warranty service calls, including travel and access.
Defines the purchaser's duties for operating and maintaining the product under warranty.
Information on consumer statutory rights relating to the product warranty.
To Next Page
General