Broan B3030SS - Connecting Ductwork and Power; Attach Damper;Duct Connector or Plate; Run and Attach House Power Cable; Hang Hood on Mounting Screws

MODELS B3030SS • B3036SS
Page 5
INSTALL THE HOOD
15 RunHouse Power Cablebetweenservicepanel
andhoodlocation.Attachpowercabletohoodusing
appropriateclamp.
16 Hanghoodfrom(4)mountingscrewsdrivenpart-wayinto
cabinetlocations(showninillustrationsunder“PREPARE
HOODLOCATION”).Mountingscrewsareincludedin
partsbag.Slidehoodbacktowardswalluntilmounting
screwheadsareengagedinnarrowendofkeyholeslots
intopofhood.Tightenscrewssecurely.
17 DUCTED INSTALLATION ONLY:
Connectductworktohoodanduseducttapetomake
jointssecureandair-tight. Makesurethedamper/duct
connectorenterstheductworkandthatthedamper
opensandclosesfreely.
HOUSE
POWERCABLE
WARNING
  Toreducetheriskofelectricalshock,switchpoweroff
  atservicepanel.Lockortagservicepaneltoprevent
  powerfrombeingswitchedonaccidentally.
ELECTRICALWIRING
BOXCOVER
13 RemoveElectrical Wiring Box Coverfrominsideofhood.
14 RemoveappropriateElectrical Power Cable Knockout
fromtoporbackofhood.
ELECTRICAL
POWER
CABLE
KNOCKOUT
12 DUCTED INSTALLATION ONLY:
Attach3¼” x 10” Damper/Duct Connector(ifusing
3¼”x10”duct)or7” Round Duct Plate(ifusing7-inch
roundduct)overtheknockoutopening.
3¼”X10”
DAMPER/
DUCT
CONNECTOR
7”ROUND
DUCT
PLATE
NOTE Toaccomodateoff-centerductwork,the3¼”x10”
 damper/ductconnectorcanbeinstalledupto½”on
 eithersideofthehoodcenterandthe7”roundduct
 platecanbeinstalledupto½”oneithersideofthe
 hoodcenter.
  Trimtheflangeontheductconnectororductplateifit
 interfereswiththeelectricalcableclamp.