618 Fabric OS Command Reference
53-1001764-02
portCfg
2
IPv6 Address Len Gateway Metric Flags
----------------------------------------------------------------
2000:: 64 * 0 U C
2000::10 128 * 0 U H L
2000::11 128 * 0 U H L
2000::1:250 128 * 0 U H L
2001:: 64 2000::1:250 0 U G
fe80:: 64 * 0 U C
ff01:: 32 * 0 U C
ff02:: 32 * 0 U C
Flags: U=Usable G=Gateway H=Host C=Created(Interface) S=Static
L=LinkLayer(Arp)
To delete a static IP route using an IPv4 address:
switch:admin> portcfg iproute ge0 delete 172.16.0.0 255.255.0.0
Operation Succeeded
To create a network-wide permanent VLAN tag entry with a VLAN ID of 200 and an L2 CoS value of
5 (no destination address):
switch:admin> portcfg vlantag ge2 add 192.168.2.10 200 5
Operation Succeeded
To display the VLAN tag configuration (for an explanation of the flags, refer to portShow):
switch:admin> portshow vlantag ge2
Port: ge2
Interface Address VlanId L2CoS Flags
Destination Address
-------------------------------------------------------------
192.168.2.10 200 5 Perm Net
0.0.0.0
192.168.0.20 100 0 Perm
192.168.0.10
192.168.0.21 200 0 Perm
192.168.0.11
2000::20 300 0 Perm
2000::10
2000::21 400 0 Perm
2000::11
switch:admin>
To delete a VLAN tag entry:
switch:admin> portcfg vlantag ge2 delete 192.168.2.10 200
Operation Succeeded
Function Commands supported only on the Brocade 7800 and the Brocade FX8-24 platforms
Synopsis portcfg action [slot/]ve_port options arguments
Description Use this command to configure FCIP tunnels and FCIP circuits on the GbE/10GbE ports on the
Brocade 7800 and FX8-24 platforms only. The FCIP tunnels on the local and remote GbE ports act
as Virtual E_Ports (VE_Ports) connecting the local and remote fabrics. The following operations can
be performed with this command:
To Next Page
