B102163-0-1113Page 36
1. Mount grill onto cart, post or base per the mounting instruc-
tions.
2. Place wind deector (ange side up) onto four raised bosses
located on the interior bottom of the grill. See Figure 23.
Figure 23
3. R3B model only: Slide ignitor spacer onto collector box as-
sembly and secure with nuts. See Figure 24.
Attention: Do not cut or damage ignitor wires.
Figure 24
Note: If a side shelf is to be installed, do so referring to the
side shelf instructions before proceeding to burner instal-
lation.
4. R3B model only: Insert collector box assembly into hole ad-
jacent to burner. The opening of the collector box should be
facing the burner. The infrared ignitor wire slides through the
empty hole next to the burner. See Figure 25.
R3B
R3
Figure 25
GRILL ASSEMBLY
To Next Page
Loading...