Brookeld Engineering Labs., Inc. Page 16 Manual No. M02-313E1209
II.9 Parameter Display
The parameter display will appear, as shown in Figure II-6, immediately after the RUN key is
pressed. All relevant measurement parameters will be shown for 5 seconds including speed,
shear rate, run time, hold time and spindle. The display will return to the default screen after
ve seconds.
Note: The viscometer will be operating according to the selected parameters while the
parameter display screen is shown.
Speed 15 RPM
Shear Rate 50 1/sec
Run 20 S Hold 10S
Spindle 04
Figure II-6
To Next Page
Loading...
