Endure Balanced Flue 22
Servicing Instructions
The following procedures can and should only be performed by Gas Safe registered
installer. The Appliance MUST be serviced annually by a Gas Safe engineer.
Removal / Replacement of gas carrying components
The removal and the replacement of gas carrying components will required the removal
of the burner tray. The following information details the removal of this tray.
Turn off the gas supply at the isolation point.
Remove the fret and stove body, place these items in a suitable location where they
cannot be damaged in any way.
Remove the top cover plate and the glass panel, take care not to damage the glass and
place in a safe location (where they cannot be damaged).
Disconnect the gas supply from the pressure test elbow.
Remove the screws securing the burner tray to the firebox, note that some screws are
located within the combustion chamber.
Re-assemble the tray in the reverse order.
Note that great care should be taken not to damage the ceramic seals which surround
most of the mating surfaces of the burner tray. If any of these are damaged they should
be replaced prior to re-assembly.
Now carefully pull the tray from the fire box, the burner tray can now be serviced or
repaired accordingly. See the following page for details.
To Next Page
Loading...
