Brother 1034D - Page 16

Serger Badge: Brother 1034D
Age: Grade 9-Adult
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
1. If upperlooper thread breaks, it may be caused by the lowerlooper thread
getting caught on the upperlooper. Lower upperlooper using the hand
wheel, remove the lowerlooper thread from the upperlooper, and
re-thread the upperlooper thread.
2. If lowerlooper thread breaks, cut and remove thread from both needles
before re-threading lowerlooper thread. Then re-thread both needle
threads.
3. After re-threading, replace the material under the presser foot and sew
3-5 cm (1 ⅛ -2 inches) over the previous stitches.
6. Properly disconnect and store the machine after
use.