8. ADJUSTMENT
BAS-311H
105
8-22-2. X-Y feed home position
1
With the power switch turned off, turn the pulley in the direction of the arrow to set the needle up stop position
(near the highest thread take-up position).
2
While pressing the ▲▼ keys simultaneously, turn on the
power switch.
･
“orG” will flash in the PROGRAM No. display and the
currently-recorded offset value will be displayed in the
menu display.
3256B 2789B
3
Press the SELECT key so that either the X-SCALE indicator or
the Y-SCALE indicator illuminates.
2790B 2401B
4
Depress the foot switch to the 2nd step (for a two-pedal foot
switch, depress the start switch).
･ Home position detection for the X-feed or Y-feed motor
will be carried out based on the currently-displayed offset
value.
･ “orG” will illuminate in the PROGRAM No. display.
* If you would like to reset, press the RESET key for 2
seconds or more at this time. Then the offset value will be
reset to “0” and home position detection for the X-feed or
Y-feed motor will be carried out.
4441Q 2791B 2634B
2nd step
To Next Page
Loading...
