11. LIST OF ERROR CODES
BAS-311H
143
Feed mechanism-related errors
Code Cause of error and remedy
E200
X-feed motor home position cannot be detected.
Problem with X-feed motor or poor X home position sensor connection.
Turn off the power, and then check that connectors P17, P21 and P8 on the main P.C. board are properly
connected.
E201
X-feed motor stopped due to a problem.
Turn off the power, and then check if there are any problems in the X-feed direction.
Turn off the power, and then check that connectors P17 and P21 on the main P.C. board are properly connected.
E204
X-feed motor stopped due to a problem during sewing.
Turn off the power, and then check if there are any problems in the X-feed direction.
Turn off the power, and then check that connectors P17 and P21 on the main P.C. board are properly connected.
E205
X-feed motor stopped due to a problem while moving to the sewing start position.
Turn off the power, and then check if there are any problems in the X-feed direction.
Turn off the power, and then check that connectors P17 and P21 on the main P.C. board are properly connected.
E206
X-feed motor stopped due to a problem during test feeding.
Turn off the power, and then check if there are any problems in the X-feed direction.
Turn off the power, and then check that connectors P17 and P21 on the main P.C. board are properly connected.
E210
Y-feed motor home position cannot be detected.
Problem with Y-feed motor or poor Y home position sensor connection.
Turn off the power, and then check that connectors P18, P22 and P8 on the main P.C. board are properly
connected.
E211
Y-feed motor stopped due to a problem.
Turn off the power, and then check if there are any problems in the Y-feed direction.
Turn off the power, and then check that connectors P18 and P22 on the main P.C. board are properly connected.
E214
Y-feed motor stopped due to a problem during sewing.
Turn off the power, and then check if there are any problems in the Y-feed direction.
Turn off the power, and then check that connectors P18 and P22 on the main P.C. board are properly connected.
E215
Y-feed motor stopped due to a problem while moving to the sewing start position.
Turn off the power, and then check if there are any problems in the Y-feed direction.
Turn off the power, and then check that connectors P18 and P22 on the main P.C. board are properly connected.
E216
Y-feed motor stopped due to a problem during test feeding.
Turn off the power, and then check if there are any problems in the Y-feed direction.
Turn off the power, and then check that connectors P18 and P22 on the main P.C. board are properly connected.
E230
Feed motor stopped due to a problem.
Reduce the sewing speed or set memory switch No.059 = 1.
To Next Page
Loading...
