Brother BAS-341F - Using Floppy Disks

6. USING THE OPERATION PANEL
BAS-341F, 342F
16
(10) Bobbin Thread COUNTER............Illuminates when bobbin thread counter mode has been selected using the menu
indicator switch (6).
(11) SPLIT NO. indicator........................Illuminates when split No. mode has been selected using the menu switch (6).
(12) Dial .................................................The setting shown on the display screen (5) can be changed by turning this dial
while pressing the STEP BACK switch (17).
(13) Bobbin Thread SET switch.................Used to store the number of work pieces displayed in the bobbin thread counter
to floppy disk.
(14) Bobbin Thread CHANGE ..............Used to continue sewing after replacing the bobbin thread.
switch (An alarm will sound when the counter reads <000>. Sewing is not possible when
the counter reads <000>.) (Refer to "6-8. Using the bobbin thread counter".)
(15) TEST switch ...................................Used to move the feed mechanism only in order to confirm a programmed stitch
pattern.
(16) TEST indicator................................Lights when the TEST switch is pressed.
(17) STEP BACK switch........................ Used when winding a fresh bobbin, or when correcting a stitch pattern due to a
(RESET switch) broken needle thread.
Also used to reset error displays.
(5)
(14)
(13)
(10)
(5)
(15)
(17)
(16)(6)
(12)
1208S
(11)