Brother BAS-342G - Page 9

BAS-342G
9. SEWING................................................51
9-1. Sewing .............................................................. 51
9-2. Using the STOP switch..................................... 52
9-3. Using the thread wiper switch .......................... 52
10. CLEANING .........................................53
10-1. Cleaning the rotary hook ................................ 53
10-2. Draining the oil................................................ 53
10-3. Checking the regulator ................................... 54
10-4. Cleaning the control box air inlet ports........... 54
10-5. Cleaning the eye guard .................................. 54
10-6. Checking the needle....................................... 54
10-7. Lubrication ...................................................... 54
11. STANDARD ADJUSTMENTS ............55
11-1. Adjusting the thread take-up spring................ 55
11-2. Adjusting arm thread guide R......................... 56
11-3. Adjusting the needle bar height...................... 56
11-4. Adjusting the needle bar lift amount ............... 56
11-5. Adjusting the driver needle guard................... 57
11-6. Adjusting the needle clearance ...................... 57
11-7. Adjusting the shuttle race thread guide.......... 57
11-8. Adjusting the rotary hook lubrication amount ... 58
11-9. Adjusting the position of the movable knife.... 59
11-10. Replacing the movable and fixed knives...... 61
11-10-1. Installing the feed plate.................. 62
11-11. Adjusting the thread wiper............................ 62
11-12. Presser foot installation position................... 63
11-13. Changing the intermittent stroke .................. 63
11-14. Adjusting the work clamp lift amount............ 65
11-15. Adjusting the air pressure............................. 65
12. TABLE OF ERROR CODES...............66
13. TROUBLESHOOTING........................70
14. 7-SEGMENT DISPLAY.......................73