Chapter 7 Operation of Machine
BES-962BC • BES-1262BC
196
5. Jog Embroidering
• Jog embroidering can be used for
preventing the thread from slipping from
the needle at the start of embroidering.
• Jog embroidering can be executed as long
as the start switch at the machine head is
held down.
Note) Never apply a tape on the switch to keep jog
operation for a long time. Doing so may cause
damage to the machine.
6. Hoop Feed Position
• In order to ease mounting and dismounting of the embroidery hoop, another needle position
can be set as a hoop feed position in the movable area additionally to the current needle
position. (The hoop feed position should be set by the personal computer.)
• In order to ease material attachment while operation is suspended, the hoop can be moved
to the feed position at any time by the hoop feed switch.
• The hoop can also be moved to the feed position automatically after embroidering is finished.
Refer to "Automatic Hoop Feed" on Page 159 for details.
BES-962BC BES-1262BC
To Next Page
Loading...
Need help?
General
