7.7.33 ADADF uF uninit (ot (onlnly fy for or momodedels ls wiwith th ADADF uF uninit)t)
(1(1)) OpOpen en ththe Ae ADF DF ununitit..
(2)(2) DiscoDisconnect thnnect the ADF sene ADF sensor harsor harness frness from the maom the main PCB ASSin PCB ASSYY..
(3)(3) Remove tRemove the tapthe taptite cup S M3xite cup S M3x8 SR screw to r8 SR screw to release thelease the ground hae ground harness of thrness of the ADF sense ADF sensoror
harness.harness.
(4)(4) Pull out Pull out the ADF sthe ADF sensor haensor harness frness from the rom the hole of thole of the machihe machine.ne.
(5)(5) Remove tRemove the two tahe two taptite binptite bind B M4x12 scrd B M4x12 screws to remews to remove the ADF uove the ADF unit from thnit from the machine machine.e.
Fig. 2-7Fig. 2-7
Harness routing: Refer toHarness routing: Refer to “
“1.1.Frame R / main PCB ASSY / low voltage power supply PCB unitFrame R / main PCB ASSY / low voltage power supply PCB unit
/ fuser unit (DCP-15** series without fan, MFC-18** series without fan)/ fuser unit (DCP-15** series without fan, MFC-18** series without fan)””,, ““22.. Frame R / mainFrame R / main
PCB ASSY / low voltage power supply PCB unit / fuser unit (DCP-15** series with fan, MFC-PCB ASSY / low voltage power supply PCB unit / fuser unit (DCP-15** series with fan, MFC-
18** series with fan)18** series with fan)””andand ““33.. Frame R / main PCB ASSY / low voltage power supply PCB unitFrame R / main PCB ASSY / low voltage power supply PCB unit
/ fuser unit (DCP-16** series, MFC-19** series)/ fuser unit (DCP-16** series, MFC-19** series)””..
ADF unitADF unit
Taptite bind B M4x12Taptite bind B M4x12
Main PCB ASSYMain PCB ASSY
ADF sensor harnessADF sensor harness
ADF sensor harnessADF sensor harness
Ground harnessGround harness
Taptite cup S M3x8 SRTaptite cup S M3x8 SR
HoleHole
To Next Page
Loading...
