(4)(4) RemRemove thove the four te four taptiaptite binte bind B M3x10 sd B M3x10 screcrews.ws.
(5)(5) ReleaRelease the hook tse the hook tray and the tray and the three hookhree hooks to removs to remove the documee the document cover frnt cover from the loweom the lowerr
document chute document chute ASSYASSY..
Fig. 2-14Fig. 2-14
(6)(6) RemRemove thove the tape taptittite bind B M3e bind B M3x10 scx10 screwrew..
(7)(7) Lift anLift and pull the fd pull the front sidront side of the reinfe of the reinforcing porcing plate to pullate to pull out it frol out it from the hole.m the hole.
(8)(8) Peel Peel it wiit with thth the doce document ument sponge sponge to thto the lefe left.t.
Fig. 2-15Fig. 2-15
Assembling Note:Assembling Note:
••
When removing the document cover, the spring could come off by removing the screw. WhenWhen removing the document cover, the spring could come off by removing the screw. When
reassembling the document cover, make sure that the spring is assembled.reassembling the document cover, make sure that the spring is assembled.
Lower document chute ASSYLower document chute ASSY
Taptite bind BTaptite bind B
M3x10M3x10
Taptite bind B M3x10Taptite bind B M3x10
HookHook
Document coverDocument cover
HooksHooks
Hook trayHook tray
SpringSpring
Reinforcing plateReinforcing plate
Taptite bind B M3x10Taptite bind B M3x10
HoleHole
Document spongeDocument sponge
To Next Page
Loading...
