Brother DCP-1623W - Page 128

2-402-40
 Confidential Confidential
unit (DCP-16** series, MFC-19** series)
unit (DCP-16** series, MFC-19** series) ..
 
77..1155 BBaacck k ccoovveerr
(1)(1) RemovRemove the four te the four taptite biaptite bind B M4x12 scrnd B M4x12 screws to remews to remove the baove the back cover frck cover from the macom the machine.hine.
(2)(2) ReleaRelease the hook hse the hook harness frarness from the secom the securing fixuring fixtures of thtures of the back cove back cover (only foer (only for modelsr models
with handset).with handset).
Fig. 2-37Fig. 2-37
Harness routing: Refer toHarness routing: Refer to “
“1010.. Hook harness (only for models with handset) (back cover)Hook harness (only for models with handset) (back cover)””..
Fi 2 38Fi 2 38
Assembling Note:Assembling Note:
•• ConnecConnect the hook harness accot the hook harness according to the followrding to the following proceduing procedures (refer to the figureres (refer to the figure
below). Engage the hook harness connector to the groove on the back cover.below). Engage the hook harness connector to the groove on the back cover. Put thePut the
hook harness through the hole "A" of the back hook harness through the hole "A" of the back cover.cover. Hook it to the guide "B".Hook it to the guide "B". Loop itLoop it
around the guide "C" once.around the guide "C" once. Put it through the hole "D".Put it through the hole "D". Release the hook harnessRelease the hook harness
connector from the groove on the back cover.connector from the groove on the back cover.
Taptite bind BTaptite bind B
M4x12M4x12
Taptite bind B M4x12Taptite bind B M4x12
Back coverBack cover
Taptite bind BTaptite bind B
M4x12M4x12
Hook harnessHook harness
(only for models with handset)(only for models with handset)
Hook harnessHook harness
Guide "C"Guide "C"
GrooveGroove
ConnectorConnector
Guide "B"Guide "B"
Hole "A"Hole "A"
Hole "D"Hole "D"
Back coverBack cover