Brother DCP-1623W

To Next Page

To Previous Page

2-482-48

 Confidential Confidential

 

7.7.2222 NeNew tw tononer er sesensnsor or PCPCB AB ASSSSYY

(1)(1) Turn Turn the macthe machine so hine so that the that the left sleft side of thide of the machine machine faces ue faces upward.pward.

(2)(2) Remove tRemove the plate up she plate up spring fropring from the platm the plate up plate ane up plate and the drive sd the drive sub ASSYub ASSY..

(3)(3) RemRemove thove the four te four taptiaptite binte bind B M4x12 sd B M4x12 screcrews.ws.

(4)(4) Remove Remove the papthe paper feed Fer feed FG sprinG spring from thg from the drive e drive sub ASSYsub ASSY..

(5)(5) Release the hook, and remove the drive sub ASSY from the machine by bending the chute earthRelease the hook, and remove the drive sub ASSY from the machine by bending the chute earth

spring inward. Remove the motor drive belt from the develop gear of the drive sub ASSY.spring inward. Remove the motor drive belt from the develop gear of the drive sub ASSY.

(6)(6) ReleaRelease the nse the new toner sew toner sensor PCensor PCB harness B harness from the from the securisecuring fixtung fixtures.res.

(7)(7) ReleaRelease the twse the two hooks o hooks to remoto remove the neve the new toner sw toner sensor PCensor PCB ASSYB ASSY..

Fig. 2-48Fig. 2-48

Note:Note:

••

Make sure that the fuser unit is at room temperature to avoid the frame deforming due to heat.Make sure that the fuser unit is at room temperature to avoid the frame deforming due to heat.



Note:Note: