1.3.81.3.8 ChecCheck conk control ptrol panel banel button utton operaoperation (tion (functfunction coion code: 13de: 13))
<Function><Function>
This function is used to check that the buttons on the control panel operate normally.This function is used to check that the buttons on the control panel operate normally.
<Operating Procedure><Operating Procedure>
(1(1)) NuNumemeriric kec key pay pad mod modedelsls
Press the [1] and [3] buttons in this order in the initial state of maintenance mode.Press the [1] and [3] buttons in this order in the initial state of maintenance mode.
Non-numeric key pad modelsNon-numeric key pad models
PrPresess ths the [e [ ] or ] or [[ ] bu] butttton ton to dio dispsplalay “My “MAIAINTENTENANANCNCE 13E 13” on ” on ththe LCe LCD anD and prd presess ths thee
[OK] button.[OK] button.
(2)(2) “00” is di“00” is displayesplayed on the LCDd on the LCD. Press the b. Press the buttons on tuttons on the controhe control panel acl panel accordincording to theg to the
numbers provided on the figure below.numbers provided on the figure below.
Each time the button is pressed, the corresponding number is displayed on the LCD inEach time the button is pressed, the corresponding number is displayed on the LCD in
decimal notation. Check that the number displayed on the LCD matches the numberdecimal notation. Check that the number displayed on the LCD matches the number
assigned to the button that has been pressed. If the buttons are pressed in the incorrectassigned to the button that has been pressed. If the buttons are pressed in the incorrect
order, “INVorder, “INVALID OPERATE” is displayed on the LCD. PrALID OPERATE” is displayed on the LCD. Press the [Stop/Exit] button, and thess the [Stop/Exit] button, and thenen
press the correct button.press the correct button.
(3)(3) When buttWhen button operation operation is normal, thon is normal, the machine rete machine returns to the initurns to the initial state of maial state of maintenanintenancece
mode when the last button is pressed. To cancel the operation and return to the initial statemode when the last button is pressed. To cancel the operation and return to the initial state
of maintenance mode, press the [Stop/Exit] button.of maintenance mode, press the [Stop/Exit] button.
To Next Page
Loading...
