1.3.131.3.13 Change USB Change USB No. return vNo. return value (function calue (function code: 45)ode: 45)
Change USB No. return valueChange USB No. return value
<Function><Function>
When the operating system (OS) installed on the computer is Windows VistaWhen the operating system (OS) installed on the computer is Windows Vista
®®
, and the, and the
machine is connected to this computer using USB2.0FULL, the OS may not be able to obtainmachine is connected to this computer using USB2.0FULL, the OS may not be able to obtain
the USB device serial number depending on the computer and USB device. If the serialthe USB device serial number depending on the computer and USB device. If the serial
number cannot be obtained, the number of devices increases each time the device isnumber cannot be obtained, the number of devices increases each time the device is
connected to the computer. To avoid this problem, setting this function to “USBNo.=ON” canconnected to the computer. To avoid this problem, setting this function to “USBNo.=ON” can
fix the USB No. return value to “0”.fix the USB No. return value to “0”.
The setting currently selected is marked “*” at the end of the display.The setting currently selected is marked “*” at the end of the display.
<Operating Procedure><Operating Procedure>
(1(1)) NuNumemeriric kec key pay pad mod modedelsls
Press the [4] and [5] buttons in this order in the initial state of maintenance mode.Press the [4] and [5] buttons in this order in the initial state of maintenance mode.
Non-numeric key pad modelsNon-numeric key pad models
PrPresess ths the [e [ ] or ] or [[ ] bu] butttton ton to dio dispsplalay “My “MAIAINTENTENANANCNCE 45E 45” on ” on ththe LCe LCD anD and prd presess ths thee
[OK] button.[OK] button.
(2)(2) “USBNo“USBNo.” is dis.” is displayeplayed on the Ld on the LCD. PreCD. Press the [Sss the [Start] btart] button.utton.
(3(3)) “U“USBSBNoNo.=.=ONON” is ” is didispsplalayeyed on d on ththe Le LCDCD. Pr. Presess ts the he [[ ] o] or [r [ ] b] bututtoton to n to didispsplalayy
“USBNo.=ON” when fixing the serial number return value to “0” or “USBNo.=OFF” when“USBNo.=ON” when fixing the serial number return value to “0” or “USBNo.=OFF” when
not fixing it.not fixing it.
(4)(4) Press the [SPress the [Start] butart] button. “Accetton. “Accepted” is dipted” is displayesplayed on the LCD, and thd on the LCD, and the machine ree machine returns toturns to
the initial state of maintenance mode.the initial state of maintenance mode.
(5)(5) TuTurn rn OFF OFF the the powpower er swiswitch.tch.
LLCCDD DDeessccrriippttiioonn
UUSSBBNNoo. . = = OONN RReettuurrn n ““00””..
UUSSBBNNoo. = . = OOFFFF RReettuurrn tn thhe se seerriiaal nl nuummbbeer or of tf thhe me maacchhiinnee. (. (DDeeffaauulltt))
Note:Note:
•• The settinThe setting is applied afg is applied after the power swter the power switch is turnitch is turned OFF and then ON agaied OFF and then ON again.n.
To Next Page
Loading...
