Unpack the machine and check the components
Read the Product Safety Guide first, then read this Quick Setup Guide for the correct
installation procedure.
NOTE:
• The available connection interfaces vary depending on the model.
• The illustrations in this Quick Setup Guide are based on the MFC‑7880DN.
USB cable
We recommend using a USB 2.0 cable (Type A/B) that is no more than 2 meters long.
Network cable (DCP‑7180DN / MFC‑7880DN)
Use a straight‑through Category 5 (or greater) twisted‑pair cable for 10BASE‑T or
100BASE‑TX Fast Ethernet Network.
Remove the packing materials and install the toner cartridge
Load paper in the paper tray
Connect the power cord and turn on the machine
Configure the machine for faxing (for MFC models only)
If you do not plan to use the fax feature on this machine, go to step 5.
A
Drum Unit
(Pre‑installed)
USB Interface Cable
Handset, Handset Cord and
Telephone Line Cord (For MFC models)
B
Inbox Toner
Cartridge
CD‑ROM
Quick Setup Guide, Product Safety Guide
and Basic User's Guide
Connect the telephone line cord
A
B
B
A
A
B
3
4
2
1
Adjust the paper guides.
Back Front
NOTE:
• To complete fax setup on your machine, see the Basic User's Guide.
• Your machine is programmed to automatically receive faxes. To change this default mode, see the Basic User's Guide.
Remove the orange part. Remove the orange part.
Quick Setup Guide
DCP‑7080 / DCP‑7080D / DCP‑7180DN / MFC‑7380 /
MFC‑7480D / MFC‑7880DN
The latest manuals are available at the Brother
Solutions Center: solutions.brother.com/manuals.
Version 0
CHN‑ENG
To Next Page
Need help?
General
