36
Installing the Driver & Software
F
Select Network Interface, and then click
Next.
G
Select Standard, and then click Next.
The application files will be copied to your
computer.
H
Select Search the network for devices
and choose from a list of discovered
devices, and then click Next.
I
If the DCP is un-configured for your network:
Select the APIPA or un-configured device
from the list and then click Next.
➝
Go to
J
If the DCP is configured for your network:
Select the DCP from the list and then click
Next.
➝
Go to
M
J
Click Configure IP Address.
K
Enter the proper IP Address information for
your network, and then click OK.
(e.g. Enter 192.168.0.105 IP Address)
L
Click Next.
For Network Interface Cable Users
(For Windows
®
98/98SE/Me/NT/2000 Professional/XP)
If you want to install the PS driver, select
Custom and then follow the on-screen
instructions. When the Select Components
screen appears, check PS Printer Driver,
and then continue following the on-screen
instructions.
If you see the following screen, click OK.
See the For Administrator section of this
guide or the NC-9100h User's Guide located
on the CD-ROM for more network
configuration information.
Step 2
To Next Page
Loading...
