2-30
Confidential
63 07 Select receiving ID not correct 2-96
74 XX DCN received 2-96
80 01 Fallback impossible. 2-96
90 01
Unable to detect video signals or commands within 6
seconds after CFR is transmitted.
2-96
90 02
Received PPS containing invalid page count or block
count.
2-96
A0 03
Error correction sequence not terminated even at final
transmission speed after fallback.
2-96
A0 11 Receive buffer empty (5-second time-out) 2-96
A0 12
Receive buffer full during operation except receiving into
memory.
2-96
A0 13 Decoding error continued on 500 lines or more. 2-96
A0 14 Decoding error continued for 15 seconds or more. 2-96
A0 15 Time-out: 13 seconds or more for one-line transmission. 2-96
A0 16 RTC not found or carrier OFF detected for 6 seconds. 2-96
A0 17
RTC found but no command detected for 60 seconds or
more.
2-96
A0 19 No video data to be sent. 2-96
A0 20 Cannot continue receiving color fax (remaining ink low). 2-96
A8 01 RTN, PIN, or ERR received (sending terminal). 2-96
A9 01 RTN, PIN, or ERR sent (receiving terminal). 2-96
AA 18 Receive buffer full during receiving into memory. 2-96
B0 01 Polarity reversion detected. 2-96
B0 02 Unable to receive the next-page data. 2-96
B0 03
Unable to receive polling even during turn-around
transmission due to call reservation.
2-96
B0 04 PC interface error. 2-96
C0 01 No common modulation mode or failed to poll. 2-96
C0 02 Unable to detect JM. 2-96
C0 03 Unable to detect CM. 2-96
C0 04 Unable to detect CJ. 2-96
C0 10 Cannot finish V. 34 negotiation or training. 2-96
C0 11 Modem error detected during V. 34 negotiation or training. 2-96
C0 20 Modem error detected during sending of commands. 2-96
C0 21 Modem error detected during receiving of commands. 2-96
C0 22 Control channel connection time-out. 2-96
C0 30 Modem error detected during sending of video signals. 2-96
C0 31 Modem error detected during receiving of video signals. 2-96
E0 01 Failed to detect 1,300 Hz signal in burn-in operation. 2-96
E0 02 Failed to detect PB signals in burn-in operation. 2-96
E0 03
Unable to detect commands in burn-in operation when
RS232C is used.
2-96
Code 1 Code 2 Cause
Refer
to.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
