Brother DCP-8155DN

29
B
B
Optional paper tray
(LT-5400)
B
An optional lower tray can be installed, and it
can hold up to 500 sheets of 80 gsm paper.
When an optional tray is installed, the
machine can hold up to 800 sheets of plain
paper.
For setup, see the Instructions that we have
supplied with the lower tray unit.
WARNING
If you use a Lower Tray, DO NOT carry the
machine with the Lower Tray as you may
be injured or cause damage to the machine
because it is not attached to the Lower
Tray.
Memory board B
DCP-8110D and DCP-8110DN have 64 MB
of standard memory, and DCP-8155DN has
128 MB. All models have one slot for optional
memory expansion. You can increase the
memory up to maximum of 320 MB for
DCP-8110D and DCP-8110DN, and 384 MB
for DCP-8155DN by installing one SO-DIMM
(Small Outline Dual In-line Memory Module).
SO-DIMM Types B
You can install the following SO-DIMMs:
 256 MB Kingston KTH-LJ2015/256
 256 MB Transcend TS256MHP423A
Note
• For more information, visit the Kingston
Technology website at
http://www.kingston.com/
.
• For more information, visit the Transcend
website at http://www.transcend.com.tw/
.
In general, the SO-DIMM must have the
following specifications:
Note
• There might be some SO-DIMMs that will
not work with the machine.
• For more information, call the dealer you
bought the machine from or Brother
Customer Service.
Options B
Type 144-pin and 16-bit output
CAS latency 4
Clock
frequency
267 MHz (533 Mb/S/Pin) or
more
Capacity 256 MB
Height 30.0 mm
DRAM type DDR2 SDRAM